Dial Tone Test (#0) - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:

Dial Tone Test (#0)

This test attempts to seize a port and checks for the return of a dial tone.
Table 65. Test #0 Dial Tone Test
Error
Code
ABORT
1000 ABORT
1001 ABORT
1002 ABORT
1004 ABORT
1005 ABORT
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test Description/ Recommendation
Result
Could not allocate system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5
times.
System resources required to run this test are not available. The port
may be busy with a valid call.
1. Use the command
trunk group/member number of the port. Use the
command to determine the service state of the port. If the service
state indicates that the port is in use, then the port is unavailable
for certain tests. You must wait until the port is idle before
retesting.
2. Retry the command at 1-minute intervals for a maximum of 5
times.
System resources required to run this test were not available. This
could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals for a maximum of 5
times.
The system could not allocate time slots for the test. The system may
be under heavy traffic conditions or it may have time slots out-of-
service due to TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals for a maximum of 5
times.
The port was seized by a user for a valid call.
display port UUCSSpp
1. Use the
trunk group/member number of the port. Use the
command to determine the service state of the port. If the service
state indicates that the port is in use, then the port is unavailable
for certain tests. You must wait until the port is idle before
retesting.
2. If the port status is idle, retry the command at 1-minute intervals
for a maximum of 5 times.
Trunk has been administered as incoming-only; dial tone can only be
obtained on outgoing trunks. This is a normal condition.
CO-TRK (Analog CO Trunk)
display port UUCSSpp
command to determine the
to determine the
status trunk
status trunk
1 of 3
127