Saki Sanity Test (#53) - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:

SAKI Sanity Test (#53)

!
CAUTION:
Table 95. TEST #53 SAKI Sanity Test
Error Test
Code Result
None ABORT
1005 ABORT
1015 ABORT
2100 ABORT
1 FAIL
2 FAIL
PASS
264
This test resets the Media Module. It is executed as part of the long test
sequence only for the Tone-Clock Media Module and DS1 interface Media Mod-
ules. Other common Media Modules can be reset with the reset board
GGGVSpp command which also executes this test.
Description/ Recommendation
System resources required for this test are not available.
Retry the command at 1-minute intervals a maximum of 5 times.
If the Media Module needs to be reset,
Media Gateway system, and the DS1
is providing timing for the platform, it cannot be reset without major platform
disruptions (Note:
local to the G700). Set the synchronization timing source to another
DS1 interface Media Module located in the same G700 and retest.
See "Setting G700 Synchronization" on page 80.
If the Media Module needs to be reset, then set synchronization to
another DS1 interface Media Module or the Tone-Clock Media
Module and try again. Refer to SYNC (Synchronization)
Maintenance documentation.
Port is not out-of-service.
Busy out the Media Module.
Execute command again.
System resources required for this test are not available.
Retry the command at 1-minute intervals a maximum of 5 times.
The Media Module failed to reset.
The Media Module failed to restart.
Execute command again.
If the problem persists, replace the Media Module.
The Media Module initializes correctly.
Run the short test sequence.
XXX-BD (Common Port Media Module)
and if this is an Avaya G700
interface Media Module under test
For this type of system the sync timing source is
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
1 of 2