Avaya G700 Maintenance Manual page 109

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 53. TEST #35 Battery Feed Test Continued
Error
Code
1392
2000
2100
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test Description/Recommendation
Result
ABORT This port is currently a TTI port and the test does not execute on it.
Verify that the port is a TTI port:
Enter the display port GGGVSpp command (the display shows
that the port is a TTI port).
Enter the list configuration command (the display shows a t for
the port).
If both commands indicate that the port is a TTI port, the abort is
correct for the test, and no action is necessary.
If either command indicates that the port is not a TTI port, escalate
the problem.
ABORT Response to the test request was not received within the allowable
time period.
ABORT System resources required to run this test are not available.
Retry the command at 1-minute intervals no more than 5 times.
If the test continues to abort, escalate the problem.
FAIL The port's battery feed chip is unable to supply sufficient power to
the terminal equipment. This test result might be marginal, and the
terminal equipment may be operating satisfactorily.
Retry the command at 1-minute intervals no more than 5 times.
If the test continues to fail, determine whether the customer is
experiencing problems on this line. Replace the Media Module only
if the customer is experiencing problems.
PASS The port's battery feed chip is able to provide sufficient power to the
station equipment to detect on-/off-hook, but may not be able to
supply power for touch-tones.
If touch-tones are inoperative on this station, replace the Media
Module because this port is inoperative.
Investigate user-reported troubles on this port by running other port
tests, by examining station wiring, or by inspecting the station.
AN-LN-PT (Analog Line Port)
2 of 3
109