Avaya G700 Maintenance Manual page 118

Gateway/ server or an
Hide thumbs Also See for G700:
Table of Contents

Advertisement

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 60. TEST #36 Port Audit and Update Test
Error
Test
Code
Result
ABORT
1000
ABORT
1006
ABORT
2000
ABORT
2100
ABORT
FAIL
PASS
118
Description/ Recommendation
Internal system error
Retry the command at 1-minute intervals for a maximum of 5 times.
System resources required to run this test were not available. The
port may be busy with a valid call.
Issue display port GGGVSPP to determine the trunk
group/member number of the port. Use the status trunk command
to determine the service state of the port. If the port is in use, wait
until the port is idle before testing.
If the port status is active but the port is not in use (no calls), check
the error log for error type 1025. The port may be locked up.
If the port status is idle, retry the command at 1-minute intervals for
a maximum of 5 times.
The DS1 CO trunk is out of service.
Use status trunk to verify that the trunk is out of service.
If the trunk is out of service, determine why.
If it is OK to put the trunk back in service, issue the release trunk
command to put the trunk back in service, and then retry the test.
Response to the test was not received within the allowable time
period.
Could not allocate the necessary system resources to run this test.
Retry the command at 1-minute intervals for a maximum of 5 times.
Test failed due to internal system error.
Retry the command at 1-minute intervals for a maximum of 5 times.
Trunk translation has been updated successfully. The current trunk
states kept in the DS1 Interface Media Module and switch software
are consistent. If the trunk is busied out, the test will not run but will
return PASS. To verify that the trunk is in-service:
Enter status trunk to verify that the trunk is in-service. If the trunk is
in-service, no further action is necessary. If the trunk is out-of-
service.
Enter release trunk to put the trunk back into in-service.
Retry the test command.
CO-DS1 (DS1 CO Trunk)
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
1 of 2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8700S8300

Table of Contents