Set Qos Control; Set Qos Rsvp - Avaya G700 Maintenance Manual

B CLI Reference for the G700 Media Gateway Processor: CLI Command Reference Pages
Administration Commands

set qos control

Privilege:Configure
Description: set qos control { local | remote }
Defines the source for QOS control parameters; either "local" which
implies that the user configures the values via the CLI or "remote" which
implies the values are obtained from the Media Gateway Controller.
Parameters:
Sample Display
MG-001-3(configure)# set qos control local
Administration Commands

set qos rsvp

Privilege:Configure
Description: set qos rsvp { {enable | disable} | refresh <secs> |
failure { retry | noretry} | profile {guaranteed | controlled} }
Sets the current value(s) for the RSVP parameters of the VoIP engines;
enabled/disabled, refresh rate (secs), failure retry (y/n), service profile
(guaranteed-service or controlled load service). WILL NOT take effect unless
QOS source setup is "local".
Parameters:
retry, service profile ([guaranteed]/controlled)
Sample Display
MG-001-3(configure)# set qos rsvp refresh 15
MG-001-3(configure)# set qos rsvp failure noretry
MG-001-3(configure)# set qos rsvp profile controlled
MG-001-3(configure)# set qos rsvp enable
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
| Processor
local or remote
| Processor
[enable]/disable, refresh rate (1-99 [15]), failure
| CC | QOS | Network | Maintenance
| CC | QOS | Network | Maintenance
| E1/T1 CSU
| E1/T1 CSU
[retry]/no
341