Set Qos Rtcp; Set Qos Signal - Avaya G700 Maintenance Manual

B CLI Reference for the G700 Media Gateway Processor: CLI Command Reference Pages
Administration Commands

set qos rtcp

Privilege:Configure
Description: set qos rtcp { {enable|disable} | monIP <ipaddress>
reportper <seconds> | listenport <portno> }
Permits the setup of RTCP parameters; enabling or disabling RTCP
reporting capability, setting the IP address of the monitor, setting
the reporting period (default= 5 sec.), and defining the listening
port number.
Parameters:
Sample Display
MG-001-3(configure)# set qos rtcp monip 132.123.23.12
MG-001-3(configure)# set qos rtcp reportper 10
MG-001-3(configure)# set qos rtcp listenport 5000
MG-001-3(configure)# set qos rtcp enable
Administration Commands

set qos signal

Privilege:Configure
Description: set qos signal { dscp | 802q } <value>
Provides the means to set up QOS signaling parameters ( DSCP, 802.1Q) for the
Media Gateway Processor.
Parameters:
Sample Display
MG-001-3(configure)# set qos signal dscp 43
342
| Processor
listen port =(1-65535,[5005]), reportper = (5-30,[5]) seconds
| Processor
dscp (0-63, [34]), 802q (0-7, [7])
| CC | QOS | Network | Maintenance
| CC | QOS | Network | Maintenance
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
| E1/T1 CSU
|
| E1/T1 CSU