Error Log Entries And Test To Clear Values - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 57. ISDN Interface Reference Point definitions
3 TN2198 ISDN-BRI 2-Wire U Interface
4 TN2198 ISDN-BRI 2-Wire U Interface
5 TN 2185 ISDN-BRI 4-Wire S Interface (Trunk Side)
* Network Termination 2 (NT2), that terminates Layer 1 and higher layers. PBXs, LANs, and
terminal controllers typically provide NT2 functionality including protocol handling and
multiplexing for Layers 2 and 3.
† Network Termination 1 (NT1), that terminates Layer 1 and monitors maintenance, perfor-
mance, timing, power transfer, multiplexing, and multi-drop termination with contention
resolution.

Error Log Entries and Test to Clear Values

Table 58. Error Log Entries and Test to Clear Values
Error Aux
Type Data
*
0 0
1 (a) Any
257 (b) 65535
513 (c) 4352
to
4357
769 (d) 4358
1025 (e)
1291 (f) 4359
3586 (g)
3840(h) 4096
to
4101
3842 (i) 46095
3843 (j) 46097
* Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the appropriate test descrip-
tion and follow the recommended procedures.
Notes:
• (a) Error Type 1 – The circuit pack stopped functioning or is physically removed from the system.
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Associated Test
Any
None
Control Channel Loop
Test (#52)
NPE/NCE Audit Test
(#50)
Clear Error Counters
(#270)
MG-BRI (BRI Trunk Media Module MM720)
Alarm On/Off Test to Clear Value
Level Board
Any Any test board GGGVM sh r 1
MINOR ON
MINOR ON test board GGGVM r 20
None ON
None ON
MINOR ON
MINOR OFF
197