Avaya G700 Maintenance Manual page 258

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 89. TEST #36 Audit and Update Test Continued
Error Test
Code Result
1006 ABORT
2000 ABORT
2100 ABORT
FAIL
PASS
Any NO
BOARD
258
Description/ Recommendation
The port is out-of-service. If the port is busied out:
Issue release access-endpoint <extension> command to put the
port back into in-service.
Retry the test command. If the port is not busied out:
Check the error and alarm logs for WAE-PORT and MM-DS1 errors
and alarms and follow the recommended repair procedures.
Response to the test request was not received within the allowable
time period.
Retry the command at 1-minute intervals a maximum of 5 times.
Could not allocate the necessary system resources to run this test.
Retry the command at 1-minute intervals a maximum of 5 times.
Internal system error
Retry the command at 1-minute intervals a maximum of 5 times.
Port translation has been updated successfully.
The test could not relate the internal ID to the port (no board). This
could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute the add ds1
GGGVS command to administer the DS1-MM interface if it is not
already administered.
If the board was already administered correctly, check the error log
to determine whether the board is hyperactive. If this is the case, the
board is shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then issue
the busyout board command.
Issue the reset board command.
Issue the release busy board command.
Issue the test board long command.
This should re-establish the linkage between the internal ID and the
port.
WAE-PORT (Wideband Access Endpoint Port)
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
2 of 2