B CLI Reference for the G700 Media Gateway Processor: CLI Command Reference Pages
output for tests.
Parameters: <voipid> - slot number where the VoIP Engine is installed. Valid
values are v0 to v4, where v0 means motherboard
Sample Display
MG-001-3(configure)# busyout voip-dsp v1
Administration Commands
clear isdn link
Privilege:All
Description: clear isdn link {<mmID><portID> | <linkID> }
Removes the ISDN link that is specified by the <linkID>. A specific link on a
specified PRI or BRI Media Module port can also be removed via this command.
Parameters:
Sample Display
MG-001-3> clear isdn link 0x0080
CAUTION: This will remove the link 0x0080
Administration Commands
clear snmp trap
Privilege:
Description: clear snmp trap { ipaddress | all }
Removes a trap receiver table entry, or will clear all of them.
Parameters:<ipaddress> is the IP address of a trap receiver.
Sample Display
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
|
Processor
<linkID> specifies the link ID (in Hex) of the desired port
Is this what you want to do [n]?
|
Processor
Configure
|
CC
|
QOS
|
Network
|
Maintenance
|
CC
|
QOS
|
Network
|
Maintenance
|
E1/T1 CSU
|
E1/T1 CSU
353