Replacing An Avaya Octaplane Stacking Module - Avaya G700 Maintenance Manual

5 G700 Component Maintenance:
Replacing an Expansion Module in the G700
Begin
Power off the unit if the equipment has been in operation.
Identify and mark all cables.
1.
2. Undo the cables.
Remove the blank plate covering the slot.
3.
4. Align the printed circuit board with the interior guide rails.
Note: The printed circuit board fits into the guide rail. The metal base plate does not.
5. Firmly press the Expansion Module until it is completely inserted into the G700.
Tighten the two screws on the front panel of the Expansion Module.
6.
End
!
WARNING:
To prevent access to electrical hazards by unauthorized personnel and to ensure
continued compliance to international radiated emissions requirements, all captive
screws must be securely tightened such that they cannot be loosened without the
use of a tool.
Replacing an Avaya Octaplane Stacking
Module
G700 Media Gateways can be mounted in equipment stacks with routers, switches, or other G700s. The
stack is limited to ten elements. To link multiple units, each G700 must be equipped with an Avaya
Octaplane Stacking Module which is mounted through the rear panel of the G700. See "Avaya
MultiVantage Solutions Hardware Guide, 555-233-200" for a general description of the hardware.
TM
Insert an Avaya Octaplane Stacking Sub-Module
Begin
Undo the cables.
1.
Remove the blank plate from the back of the G700.
2.
Insert theAvaya Octaplane Stacking Sub-Module gently in the slot, ensuring that the metal base
3.
plate is aligned with the guide rails.
Press the Avaya Octaplane Stacking Sub-Module in firmly until the connector at the back of the
4.
module is completely inserted into the internal connector on the G700.
Tighten the screws on either side of the module.
5.
End
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Media Module Replacement
79