Avaya G700 Maintenance Manual page 113

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 55. TEST #48 Station Present Test Continued
Error
Code
1000
1004
1005
1008
1018
2000
2100
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test Description/Recommendation
Result
ABORT System resources are unavailable. The port may be busy with a
valid call. This result is also reported for the system's Music-On-
Hold port when it is off-hook, which it usually is.
Enter display port GGGVSpp to determine the station's extension.
Enter status station extension to determine the service state of
the port.
If the port is in use, wait until the port is idle. Retry the command at
1-minute intervals no more than 5 times.
If the test continues to abort, escalate the problem.
ABORT A valid call seized the port during the test and aborted the test.
Use the display port GGGVSpp command to determine the station
extension.
Use the status station extension command to determine the
service state of the port.
If the port is in use, wait until the port is idle before testing. Retry the
command at 1-minute intervals no more than 5 times.
If the test continues to abort, escalate the problem.
ABORT This test was aborted due to a configuration problem. The test is not
applicable for this type of analog port. This error can be ignored.
ABORT A ringing circuit could not be allocated. Retry the command at 1-
minute intervals no more than 5 times.
Check for Error Type 257 in the hardware error log. Resolve, if
present.
ABORT Administration has disabled the test. The default for the Test? field
on the station form is y . Determine why this field has been set to n
on this station (this may be due to the ringing application Test 48,
which can be disturbing to customer or terminal equipment).
To enable the test for a particular station being tested, enter change
station extension.
Change the Test? field on the station form to y .
ABORT Response to the test request was not received within the allowable
time period.
ABORT System resources required to run this test are not available.
Retry the command at 1-minute intervals no more than 5 times.
If the test continues to abort, escalate the problem.
AN-LN-PT (Analog Line Port)
2 of 3
113