Avaya G700 Maintenance Manual page 74

5 G700 Component Maintenance:
5. Align the LED module in its guides and gently push it into place, keeping the LED module safely
within its guides and maintaining an even pressure to assure that the module does not become
twisted or disengage from the guides.
Guide the longer, left side of the LED module into the chassis until the shorter, right edge of the
module can engage in its guides.
Figure 1. Align the LED module and the S8300 Media Server
Push steadily and firmly until the faceplates of the S8300 Media Server and the LED module are
6.
even and then push the two units into the housing together.
Apply firm pressure to engage the connectors.
7.
The connector has different length pins. The long pins will engage first to provide grounding.
Medium length and short pins will provide power and signal.
8. Tighten the captive screws on the S8300 Media Server
!
WARNING:
To prevent access to electrical hazards by unauthorized personnel and to ensure
continued compliance to international radiated emissions requirements, all captive
screws must be securely tightened such that they cannot be loosened without the
use of a tool.
74
(Figure 1)
module.(Figure
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
G700 Component Maintenance
2)