Avaya G700 Maintenance Manual page 189

6 Avaya MultiVantage Software-Controlled Maintenance:
For interfaces not using country protocol 1, the Service State Audit executes only if the trunk is in the
out-of-service/far-end state. A message is sent to the far-end switch to attempt to bring the trunk back
into the in-service state. A PASS for this test simply means that the message has been successfully
sent. Two minutes are allowed for a reply. If no reply is received within that two minute window, the
message is sent out again. If again no response is received within two minutes, the trunk remains in
the out-of-service/far-end state. The switch will attempt another Service State Audit after an hour has
passed.
To investigate the service state of the DS1 ISDN Trunk, issue the status trunk group#/member#
command.
Table 49. TEST #256 Service State Audit Test
Error
Code
1000
1018
1113
1114
1116
1117
2100
1113
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test Description/ Recommendation
Result
ABORT Resources required to run this test were not available. The port may
be on a valid call or initializing. Use status station or status trunk to
determine when the trunk is available for testing. Check the results of
Test #255.
ABORT Maintenance is disabled on this trunk.
Enable maintenance by entering "y" in the "Maintenance Tests?" field
on page 2 of the change trunk-group form.
ABORT The signaling link has failed, so the system cannot send any
messages on behalf of this trunk.
Check the results of Test #255 and consult procedures for ISDN-
SGR (ISDN-PRI Signaling Group) in this chapter.
ABORT The signaling link is in a transitional state.
Retry the command at 1-minute intervals for a maximum of 5 times.
ABORT The trunk is not in the out-of-service/far-end state, which is required
to run this test on systems using a country protocol other than 1.
ABORT A service state audit message is outstanding.
Wait 2 minutes and then try again.
ABORT Could not allocate the necessary system resources to run this test.
Retry the command at 1-minute intervals for a maximum of 5 times.
FAIL The signaling link has failed; the system cannot send any messages
on behalf of this trunk.
Consult procedures for ISDN-SGR (ISDN-PRI Signaling Group) and
ISDN-LNK ( ISDN Signaling Link Port).
FAIL Internal system error
Retry the command at 1-minute intervals for a maximum of 5 times.
ISDN-TRK (DS1 ISDN Trunk)
1 of 2
189