Signaling Link State Check Test (#255) - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 47. TEST #36 Audit and Update Test Continued
Error
Code
Any

Signaling Link State Check Test (#255)

The DS1 ISDN Trunk depends on the health of the appropriate MM710 Interface Media Module. It
also depends on the ISDN-PRI D-channel (ISDN-LNK) trunk. This test checks the status of those
critical elements.
Table 48. TEST #255 Signaling Link State Check Test
Error
Code
None
0
1114
1018
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test Description/ Recommendation
Result
PASS Trunk translation has been updated successfully. The current trunk
states kept in the DS1 interface Media Module and switch software
are consistent.
NO The test could not relate the internal ID to the port (no board). This
BOARD could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute the add ds1
GGGVS command to administer the DS1-MM interface if it is not
already administered.
If the board was already administered correctly, check the error log to
determine whether the board is hyperactive. If this is the case, the
board is shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then issue
the busyout board command.
Issue the reset board command.
Issue the release busy board command.
Issue the test board long command.
This should re-establish the linkage between the internal ID and the
port.
Test Description/ Recommendation
Result
ABORT Internal system error
ABORT
ABORT The signaling link is in a transitional state.
Retry the command at 1-minute intervals for a maximum of 5 times.
ABORT Maintenance is disable on this trunk.
Enable maintenance by entering "y" in the "Maintenance Tests?" field
on page 2 of the change trunk-group form.
ISDN-TRK (DS1 ISDN Trunk)
2 of 2
1 of 2
187