Avaya G700 Maintenance Manual page 89

6 Avaya MultiVantage Software-Controlled Maintenance:
The G700 Media Gateway Primary Server administers the G700 Media Gateways by the command
add media-gateway x or add media-gateway next, where x is valid between the range of 1 to the
capacity for a given primary server, and next is the next available number to be administered.
The commands change media-gateway x, display media-gateway x , and remove media-gateway
x are supported in the same manner as the add media-gateway x command.
The Media Gateway form has five administrable fields for identification:
• Name -- A twenty (20) character open field for customer naming of the gateway. The default is a
blank field.
• Identifier -- A twenty (20) character field for the controller to identify the gateway. The default is a
blank field.
• Network Region -- A two or three character field for use by the primary server to allocate resources
from the nearest Media Gateway. The of characters is dependent upon the type of primary server.
The default is a blank field.
• Location -- A two character field, which refers to a time-zone offset, day-light savings rule, and
number plan area code. The default is one (1).
• Site Data -- Two lines of 20 characters for general site information. The default is a blank field.
The 'Registered?' field is one (1) character long for indicating whether a G700 Media Gateway is
currently registered with the primary server or not. The 'Registered?' field is a display only field. The
valid value that the 'Registered?' field can have is y(es) or n(o).
The Media Gateway form has two additional fields for display purposes only: IP Address and MAC
Address.
The IP Address field is a 15 character display only field containing the IP Address of the media
gateway. The data in this field is of the form: XXX.XXX.XXX.XXX (where XXX is a decimal value
between 000 and 255). The IP address field returns a blank field until the Media Gateway registers for
the first time. Once the G700 has registered, that IP address will always be displayed, even if the
G700 becomes unregistered, until a G700 with a different IP address is validly registered with the
same administered identifier. The populated IP address is persistent over reboots.
The MAC Address field is a 17 character display only field containing the MAC Address of the
media gateway. The data in this field is of the form: XX:XX:XX:XX:XX:XX (where XX is a
hexadecimal value between 00 and FF). The MAC Address field returns a blank field until the G700
registers for the first time. Once the G700 has registered, that MAC Address will always be displayed,
even if the G700 becomes unregistered, until a G700 with a different MAC Address is validly
registered with the same administered identifier.
The G700 Media Gateway Media Modules are listed by Slot V1-V4, followed by the input field for
'Module Type'. The Media Modules shall be one of six types: analog, bri, dcp, icc, voip, or ds1 (also
referred to as E1/T1). The default for the Module Type field is a blank field.
Note: The S8300 Media Server and LSP are both processor-type Media Modules. From
a SAT administration view-point, there is no difference between the S8300 Media
Server and LSP; therefore, the designation for both is via icc in the Module Type
field.
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
DEFINITY Server Equivalent Elements
89