Avaya G700 Maintenance Manual page 249

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 82. TEST #36 Audit and Update Test Continued
Error
Code
1000
1006
2000
2100
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test Description/ Recommendation
Result
ABORT System resources required to run this test were not available. The
port may be busy with a valid call.
Use the display port GGGVSpp command to determine the trunk
group/member number of the port. Use the status trunk command
to determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable for
certain tests. You must wait until the port is idle before retesting.
If the port status is active but the port is not in use (no calls), check
the error log for error type 1025 (see the error log table for a
description of this error and required actions). The port may be
locked up.
If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
ABORT The test was aborted because the trunk is out of service.
Use the status trunk command to verify that the trunk is out of
service.
If the trunk is out of service, determine why.
If it is OK to put the trunk back in service, issue the release trunk
command to put the trunk back in service, and then retry the test.
ABORT Response to the test request was not received within the allowable
time period.
ABORT Could not allocate the necessary system resources to run this test.
Retry the command at 1-minute intervals a maximum of 5 times.
FAIL Internal system error.
Retry the command at 1-minute intervals a maximum of 5 times.
PASS Trunk translation has been updated successfully. The current trunk
states kept in the DS1 Interface Media Module and switch software
are consistent. If the trunk is busied out, the test will not run but will
return PASS. To verify that the trunk is in-service:
Enter the status trunk command to verify that the trunk is in-service.
If the trunk is in-service, no further action is necessary. If the trunk is
out-of-service, continue to step 2.
Enter the release trunk command to put the trunk back into in-
service.
Retry the test command.
TIE-DS1 (DS1 Tie Trunk)
2 of 3
249