Set Logout; Set Sync Interface - Avaya G700 Maintenance Manual

B CLI Reference for the G700 Media Gateway Processor: CLI Command Reference Pages

set logout

Privilege:
Description: set { logout | timeout }[<minutes>]
Both logout and timeout perform the same. Sets the CLI inactivity time-out
value in minutes. A value of "0" implies no timeout. When the timer is set >
0 the user will be automatically logged out if idle time is > than the set
value. No argument implies the use of the default value of 15 seconds.
Parameters:
Default = 15 minute. Value of '0' results in no time-out. Range is 0-999 min-
utes.
Sample Display
MG-001-3(configure)# set logout 20
Sessions will be automatically logged out after 20 minutes of idle time.
MG-001-3(configure)# set logout 0
Sessions will not be automatically logged out.
Administration Commands

set sync interface

Privilege:
Description: set sync interface { primary | secondary } {<mmID>|<portID>}
Defines a potential stratum clock source (E1/T1 MM, ISDN-BRI) Setting source
to primary, normal failover will occur. Setting source to secondary overrides
normal failover, gen a trap, and assert a fault. Not stored in persistent
storage.
Parameters:
the form "vn" where "n" is the MM slot number. For BRI MM, a "portID" is
depicted by combining the mmID of the MM to the port number of the BRI port
322
Configure
The number of elapsed minutes for timing out the CLI connection.
| Processor
Configure
<mmID> is the Media Module ID of a MM stratum clock source of
| CC | QOS | Network | Maintenance
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
| E1/T1 CSU