Anl-Line (8-Port Analog Line), Anl-Ne-L (8-Port Neon Analog Line) - Avaya Definity SI Maintenance Manual

Table of Contents

Advertisement

Maintenance Object Repair Procedures
ANL-LINE (8-Port Analog Line),
ANL-NE-L (8-Port Neon Analog Line)
MO Name (in
Alarm Log)
ANL-LINE
ANL-LINE
ANL-NE-L
ANL-NE-L
1
Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the carrier
designation (for example, A, B, C, D, or E); SS is the address of the slot in the carrier
where the circuit pack is located (for example, 01, 02, etc.); and pp is the 2-digit port
number (for example, 01).
The 8-Port Analog Line circuit packs are:
TN742
TN769
TN712
These circuit packs provide eight ports for single line on-premises or off-premises
analog endpoints such as analog voice terminals, queue warning level lamps,
recorded announcements, dictation machines, PagePac
external alerting devices, modems, facsimile machines, and AUDIX voice ports.
The TN769 supports a neon message waiting lamp. The other eight-port analog
lines do not support the lamp.
Test #48 may cause some terminal equipment to ring briefly during daily
maintenance. If this ringing is disturbing the customer or the terminal equipment, it
should be disabled using the Tests field of the station administration screen.
However, on some releases of the software, this action disables Tests #6, #47,
and #35 as well as Test #48. Test #47 may cause a false alarm when the port is
connected to off-premises equipment, some non-voice terminal equipment, and
some loop equipment. If this is the case, then the test should be disabled using
the Tests field of the change station <extension> command.
No maintenance of the terminal connected to the 8-Port Analog Line circuit pack
or 8-Port Neon Analog Line circuit pack is performed, except to determine
whether or not the terminal is connected. Failures of the neon message waiting
lamp power (for ANL-NE-L only) and the common ringing application circuitry are
reported as part of the Common Port Circuit Pack errors (see errors 1281 and
1793 in the XXX-BD (Common Port Circuit Pack) Maintenance documentation).
10-86
Issue 4 May 2002
Alarm
Initial Command to
Level
MIN
test port PCSSpp l
WRN
test port PCSSpp sh
MIN
test port PCSSpp l
WRN
test port PCSSpp sh
TN431 [G3iV2-386]
TN443 [G3iV2-386]
TN467 [G3iV2-386]
TN411 [G3iV2-386]
1
Run
Full Name of MO
8-Port Analog Line
8-Port Analog Line
8-Port Neon Analog Line
8-Port Neon Analog Line
paging equipment,
555-233-123

Advertisement

Table of Contents
loading

Table of Contents