Reset; Retstatus - Avaya G700 Maintenance Manual

B CLI Reference for the G700 Media Gateway Processor: CLI Command Reference Pages

reset

Privilege:
Description: reset { mgp | voip { voipID } |
This command resets a specified system resource. It permits a hard reset of
the specified entity, returning any selectable parameters to the configura-
tion in place before the reset and setting all hardware and firmware to a
known state.
Parameters:
mmID of "v0" is NOT allowed as this ID is for the motherboard. The motherboard
reset is handled by the 'reset mgp' command. 'voipID' is in the range v0-4 .
Sample Display
MG-001-3(configure)# reset mgp
This command will perform a hard reset.
Do you want to continue (Y/N)? y
Connection closed by foreign host.
MG-001-3(configure)# reset voip v0
This command will perform a hard reset.
Do you want to continue (Y/N)? y
Administration Commands

retstatus

Privilege:All
Description: retstatus
Shows the pass/fail status of last command. Use this command to show whether
or not the last CLI command you performed was successful.
Parameters:
Sample Display
MG-001-2> retstatus
320
Configure
Selection of MGP or a specific resource. Range of mmID is v1-v4.
| Processor
None
{ mm <mmID>} }
| CC | QOS | Network | Maintenance
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
| E1/T1 CSU