Control Channel Looparound Test (#52) - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 93. Technician-Demand Tests Continued
Order of Investigation
Neon Test (#220) (c)
Note: This Test will ABORT with
code 1412
*D = Destructive; ND = Nondestructive
Notes:
• (a) Only applicable to Analog Line Media Modules.
• (b) The SAKI Sanity Test is run on other Media Modules only when they are reset via the reset
board command.
• (c) Only applicable to MM711 Analog Line Media Modules.

Control Channel Looparound Test (#52)

This test queries the Media Module vintage and verifies its records.
Table 94. TEST #52 Control Channel Looparound Test
Error
Code
None
2100
Any
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test Description/ Recommendation
Result
ABORT System resources required for this test are not available.
Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The test failed because the Media Module failed to return the Media
Module code or vintage.
Retry the command for a maximum of 5 times.
If the test still fails, issue the busyout board , reset board , and
release busy board commands, and then retest.
If the problem continues, replace the Media Module.
Run the test again.
PASS Communication with this Media Module is successful.
NO This is normal if the test is being done when (a) the board is not
BOARD physically in the system or (b) the system is booting up. Otherwise,
there is some inconsistency between the physical configuration and
the data kept in the system.
Verify that the board is physically in the system.
Verify that the system is not in a stage of booting up.
Retry the command at 1-minute intervals for a maximum of 5 times.
XXX-BD (Common Port Media Module)
Short Test Long Test
Sequence Sequence
X X
Reset D/ND*
Board
Sequence
ND
263