Avaya G700 Maintenance Manual page 293

9 G700 and Media Module LEDs:
Table 109. mgp-001-1(configure)# set sync interface primary v4
mgp-001-1(configure)# show sync timing
SOURCE
Primary
Secondary
Local
Comment: No failures, Sig is green and ACT On 2.7s off 0.3s
Note that the MM710 in slot 4 has been declared to be the primary sync source but it is
not active until the next command is issued
Table 110. mgp-001-1(configure)# set syn source primary
mgp-001-1(configure)# show sync timing
SOURCE
Primary
Secondary
Local
Comment: The ACT LED does not change its behavior.
To test for slippage, from the SAT issue the command:
test mo logical 4255 physical 1v4 test 144
The results from the above command are given in
Table 111. TEST RESULTS
Port
001V4
Command successfully completed
If a secondary is similarly provisioned:
Table 112. mgp-001-1(configure)# set syn int sec v3
mgp-001-1(configure)# sho syn tim
SOURCE
Primary
Secondary
Local
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
MM
V4
V0
MM
V4
V0
Maintenance Alt. Name
Name
MG-DS1 144
MM
V4
V3
V0
STATUS
Locked OUt
Not Configured
Active
STATUS
Active
Not Configured
Standby
Table 111:
Test No.
Result
PASS
STATUS
Active
Standby
Standby
Media Module LEDs
FAILURE
None
None
FAILURE
None
None
Error Code
FAILURE
None
None
None
293