Avaya G700 Maintenance Manual page 210

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 63. Test #52 Control Channel Looparound Test
Error Test
Code Result
None ABORT
2100
FAIL
PASS
Any NO
BOARD
210
Description/ Recommendation
System resources required for this test are not available.
Retry the command at 1-minute intervals a maximum of 5 times.
The Media Module failed to return the Media Module code or
vintage.
Retry the command a maximum of 5 times.
If the problem continues, replace the Media Module.
Retry the command a few times a maximum of 5 times.
Communication with this Media Module is successful.
The test could not relate the internal ID to the port (no board). This
could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute the add ds1
GGGVS command to administer the DS1-MM if it is not already
administered.
If the board was already administered correctly, check the error log
to determine whether the board is hyperactive. If this is the case, the
board is shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then issue
the busyout board command.
Issue the reset board command.
Issue the release busy board command.
Issue the test board long command.
This should re-establish the linkage between the internal ID and the
port.
MG-DS1 (DS1 Interface Media Module)
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002