Error Log Entries And Test To Clear Values - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:

Error Log Entries and Test to Clear Values

Table 13. DID Trunk Error Log Entries
Error
Type
0*
1(a)
1(b)
1(c)
1(d)
15(e)
18
130(f)
257(g)
257(h)
257(i)
257(j)
513(k)
513(l)
769
1537
*Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer
to the appropriate test description and follow the recommended procedures.
**Major alarms may be downgraded to Warning alarms based on the value used in the
set options command.
Notes:
See also the preceding section on trunk problems without errors or alarms.
• (a) This condition occurs when the tone detector times out waiting for digits. Change
wink/immediate-start parameter to wink/immediate-start and rotary/tone-dial parameters.
1) Verify trunk administered wink/immediate-start parameter.
2) Test trunk using BUTT set.
3) Refer problem to CO .
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Aux Associated Test
Data
0 Any
Any None
57476 None
57477 None
57483 None
Any Port Audit Update
(#36)
0 busyout trunk
grp/mbr
None
57472 None
57473 None
57474 None
57475 None
57392 None
57393 None
Any Port Diagnostic
(#35)
Any Port Diagnostic
(#35)
DID-TRK (Direct Inward Dial Trunk)
Alarm On/Off
Level Board
Any Any
WRN OFF
WRN OFF
WRN OFF
WRN OFF
WRN OFF
WRN ON
WRN OFF
WRN OFF
WRN OFF
WRN OFF
MIN/ OFF
WRN **
MIN/ ON
WRN**
MAJ/ MIN/ OFF
WRN**
Test to Clear Value
test port GGGVSpp
sh r 1
release trunk
grp/mbr
test trunk grp/mbr
test port GGGVSpp
r 3
test port GGGVSpp
r 3
139