Media Gateway - Network Cli Commands; Network; Media Gateway - Maintenance Cli Set; Maintenance - Avaya G700 Maintenance Manual

B CLI Reference for the G700 Media Gateway Processor: Media Gateway - Network CLI Commands

Media Gateway - Network CLI Commands

Network

These commands are used to set/display /change IP parameters associated with the MGC and VOIP
engines. Included is 'ping' command used to test a network path to a specific IP address.
clear arp-cache
clear ip route
ping
session
set interface
set ip route
show interface
show ip arp
show ip route
telnet
traceroute mgp

Media Gateway - Maintenance CLI Set

Maintenance

These commands are used to perform maintenance on the MGP. Use these commands to display voltages,
faults and temp readings. This family of commands is used set/display/change SNMP parameters for the
MGP. Commands are also available to upload and download configuration files and to display and reset
ISDN links associated with Media Modules.
busyout | test | release voip-dsp
clear isdn link
clear snmp trap
copy mgp-config tftp
312
Deletes all ARP cache entries
Removes entry(ies) from routing table.
Tests network path to target IP address.
Creates a session to the MGC, SAT, or stack.
Sets up IP for MGP or VoIP engine.
Adds a route to routing table.
Shows defined IP interface.
Shows the ARP cache.
Shows IP routing table.
Initiates a TELNET session
Shows route of IP packet from origin to destination
Provides the ability to busyout/test/release a VoIP
engine.
Removes a specified ISDN link.
Removes one or all trap receivers
Uploads the MG configuration file.
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002