B CLI Reference for the G700 Media Gateway Processor: Media Gateway - Call Controller ( CC ) CLI
Media Gateway - Call Controller ( CC ) CLI
Commands
CC
These commands are used to set/display/change the ip address list of the Media Gateway Call Controller.
The show mgp command can be used to display the active MG controller state and setup.
clear mgc list
set mgc list
show mgc
show mgc list
Media Gateway - Quality of Service (QoS) CLI
Commands
QOS
These commands are used to set/change/display the parameters associated with the bearer related QOS for
the MGP and VoIP engines.
set qos bearer
set qos control
set qos rsvp
set qos rtcp
set qos signal
set qos rtcp
show voip-parameters
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Removes one or all entries within the MGC list.
Adds one or more entries to the MGC list.
Shows the active MGC state and setup
Displays the list of available MGC's
Sets QOS bearer configuration.
Defines source of QOS parameters.
Establishes RSVP parameter settings.
Sets RTCP operation mode and parameters.
Sets the DSCP or 802.1Q priority value.
Shows QOS parameters.
Shows a VoIP engine's setup and state.
Commands
311