Port Audit Update Test (#36) - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 6. TEST #3 CO Demand Diagnostic Test Continued
Error
Code
Any

Port Audit Update Test (#36)

This test will send updates of the CO port translation for all ports on the Media Module which have
been translated. The update is non-disruptive and guards against possible corruption of translation
data contained on the Media Module. No response message is expected from the Media Module once
it receives translation updates. The port translation data includes: ground or loop start trunk, tone or
rotary dialing trunk, rotary dialing inter-digit timing, network balance R/RC, and disconnect timing.
Table 7. TEST #36 Port Audit Update Test
Error
Code
1006
2100
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test Description/ Recommendation
Result
PASS This test verifies that the port is able to apply ground for outgoing
calls and detect ground for incoming calls; however, it does not
provide information on whether a CO line is actually connected.
User-reported troubles on this port should be investigated by using
other port tests and by examining trunk or external wiring.
NO The test could not relate the internal ID to the port (no board).
BOARD
Check to ensure that the board translations are correct. Translate the
board, if necessary.
Issue the busyout board command.
Issue the reset board command.
Issue the release busy board command.
Issue the test board command. This should re-establish the linkage
between the internal ID and the port.
Test Description/ Recommendation
Result
ABORT Could not allocate the necessary system resources to run this test.
Retry the command at 1-minute intervals for a maximum of 5 times.
ABORT The port has been placed out of service, perhaps by craft busyout.
Use the display port GGGVSpp command to determine the trunk
group/member number of the port. Use the status trunk command
to determine the service state of the port. If the service state
indicates that the port is in use, wait until the port is idle before
testing.
If the port status is idle, retry the command at 1-minute intervals for
a maximum of 5 times.
ABORT System resources required to run this test were not available.
If the port status is idle, retry the command at 1-minute intervals for
a maximum of 5 times.
CO-TRK (Analog CO Trunk)
131
3 of 3
1 of 2