Avaya G700 Maintenance Manual page 114

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 55. TEST #48 Station Present Test Continued
Error
Code
Any
114
Test Description/Recommendation
Result
FAIL The terminal equipment is not connected to the Media Module.
Some terminal equipment, such as modems, may fail even when
connected properly.
Remotely test the terminal equipment.
If the test fails again, resolve any RING-GEN errors in the error log,
if present.
Check all of the wiring between the station equipment and the
switch. Then, run the test again.
Some terminal equipment might fail even when it is connected
properly. If this is the case, disable the test using the change
station extension command (enter n into the Test field). Note that
this action also disables Test #35 on this port.
If the test still fails, the terminal equipment may be defective. Check
and replace it, if necessary.
PASS The station is connected properly to the switch. Investigate user-
reported troubles on this port by running other port tests, by
examining station wiring, or by inspecting the station.
This test may also pass if no terminal equipment is connected and
the terminal is located very far from the switch.
NO The test could not relate the internal ID to the port (no board). This
BOARD result could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
Check to make sure that the board translations are correct. Use the
list configuration command, and resolve any problems.
If the board is correctly inserted, issue the busy board GGGVS
command.
Issue the reset board GGGVS command.
Issue the release board GGGVS command.
Issue the test board GGGVS long command. This re-establishes
the link between the internal ID and the port.
If this is not the case, check to make sure that a valid board is
inserted.
AN-LN-PT (Analog Line Port)
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
3 of 3