Appendix B Cli Reference For The G700 Media Gateway Processor; Introduction; Media Gateway - Administration Cli Set; Administration Commands - Avaya G700 Maintenance Manual

B CLI Reference for the G700 Media

Introduction

This is the Command Line Interface reference document for the Avaya G700 Media Gateway Processor.
Click on the command name in blue to go to the reference page for the selected command.
At the top of each command reference page is a navigation bar. Click on the category name to return to the
respective category table at the beginning of the document.

Media Gateway - Administration CLI Set

Administration Commands

The following commands are used for general administration on the G700 Media Gateway Processor. The
commands are listed alphabetically for ease of reference:
clear screen
clear sync interface
configure
dir
exit
hostname
help
nvram initialize
reset
retstatus
sat
set hostname
set logout
set sync interface
set sync source
set system contact
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Gateway Processor
Clears the screen and homes the cursor
Disassociates an interface as a sync source
Permits the use of set commands
Shows list of downloadable files
Exit the session or current mode
Places 'hostname'in the command prompt
Shows mode-specific command help
Clear NVRAM and reload factory defaults
Resets a specified system resource
Shows pass/fail status of last command
Sets up session with the SAT
Places 'hostname' in the command prompt
Sets idle time for auto-logout
A mode that permits change to the sync configuration
Specifies the stratum clock source
Sets the site contact name
309