Station Status And Translation Audits And Updates Test (#36) - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 53. TEST #35 Battery Feed Test Continued
Error
Code
Any
Station Status and Translation Audits and
Updates Test (#36)
This test updates the analog port's message lamp state (if it has one) and translations with information
in the software.
Table 54. TEST #36 Station Status and Translation Audits and Updates
Error
Code
1004
110
Test Description/Recommendation
Result
NO The test could not relate the internal ID to the port (no board). This
BOARD result could be due to incorrect translations, no board is inserted,
an incorrect board is inserted, or an insane board is inserted.
Check to make sure that the board translations are correct. Use the
list configuration command, and resolve any problems.
If the board is correctly inserted, issue the busy board GGGVS
command.
Issue the reset board GGGVS command.
Issue the release board GGGVS command.
Issue the test board GGGVS long command. This re-establishes
the link between the internal ID and the port.
If this is not the case, check to make sure that a valid board is
inserted.
Test Description/ Recommendation
Result
ABORT Necessary system resources could not be allocated to run this test.
Retry the command at 1-minute intervals no more than 5 times.
If the test continues to abort, escalate the problem.
ABORT A valid call seized the port during the test and aborted the test.
Use the display board GGGVSpp command to determine the
station extension.
Use the status station extension command to determine the
service state of the port.
If the port is in use, wait until the port is idle before testing. Retry
the command at 1-minute intervals no more than 5 times.
If the test continues to abort, escalate the problem.
AN-LN-PT (Analog Line Port)
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
3 of 3
1 of 3