Media Module Replacement - Avaya G700 Maintenance Manual

5 G700 Component Maintenance:
Table 36. Equipment List: Media Modules Continued
Media Modules
Material Code: 170899
ComCode (for Maintenance Ordering Only): 108919960

Media Module Replacement

There are several reasons for replacing a Media Module:
• Repairing a damaged Media Module
• Changing Media Module type
The modules on the G700 are not inserted until the G700 registers with Avaya MultiVantage.
Likewise, all Media Modules and associated Maintenance Objects are removed if the G700 link goes
down.
The term 'board insertion process' refers to the process in which the Media Modules are queried as to
their type, suffix, and vintage. Use the 'list config all' or 'list congfig media-gateway <#>' commands
to access this information.
Any Media Module that does not agree with administration generates a process error and is flagged to
the relevant administration form.
The removal of the Media Modules is detected. Listings of the G700 circuit packs show the relevant
slot location as having 'no board.'
The determination of E1/T1 modes of operation for the DS1 Media Modules is downloadable, since
the DS1 Media Module can function as either a T1 or E1 interface.
Media Module Replacement
Upon Media Module replacement, modules are registered with the G700 Media Gateway, where board type,
suffix, and vintage are verified. The G700 then sends appropriate H.248 messages to the controller, thus
creating MultiVantage objects.
For detailed descriptions of the Media Modules see "Avaya MultiVantage
555-233-200."
!
WARNING:
The G700 must not be operated with any slots open; empty slots should be covered
with the supplied blank plates.
76
Analog Station/Trunk Media Module
Apparatus Code: DMM4
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Media Module Replacement
Optional
TM Solutions Hardware Guide,
2 of 2