Error Log Entries And Test To Clear Values - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:

Error Log Entries and Test to Clear Values

Table 26. DIOD Trunk Error Log Entries
Error
Type
0*
15 (b)
18
769 (a)
1537 (f)
2561 (a,d)
2817 (a,e)
3073 (a,c)
3585 (a,c)
*Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer
to the appropriate test description and follow the recommended procedures.
**Major alarms on this MO may be downgraded to Warning alarms based on the value
used in the set options command. If the Minor alarm is not downgraded by the set-
options values, the Minor alarm is upgraded to a Major alarm if 75 percent of the trunks
in this trunk group are alarmed.
Notes:
• (a) These are in-line errors that have no specific test associated with them. Refer to the following
Table 27 for an explanation and appropriate action.
• (b) This is a software audit error and does not indicate any hardware malfunction. Run the Short
Test Sequence and investigate associated errors.
• (c) Aux data 57376
Aux data 57424
These errors cause the Dial Tone Test (#0) to run and are only considered a problem if the Dial
Tone Test fails (in which case Error Type 1537 also appears). In this case, the trunk may be put in
''Ready-for-Service'' state (shown as ''disconnected'' by status command), which allows only
incoming calls. Run the Dial Tone Test (#0) and follow its procedures.
• (d) Single polarity ringing current
prevent the incoming call from being accepted. This error code is logged for information purposes
only and does not cause additional testing to occur.
• (e) Late CO Trunk release
the PBX dropped the call. This error code is only logged as an informational event and causes no
other testing to occur.
• (f) Dial-Tone Test
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Aux Associated Test
Data
0 Any
any Port Audit Update
Test (#36)
0 Busyout trunk
grp/mbr
57392 None
57345 None
57393 None
57376 None
57424 None
—
No loop current on incoming call
—
No loop current on outgoing call
—
This error results from abnormal ringing current, but does not
—
This indicates that the CO releases the trunk at least four minutes after
DIOD-TRK (DIOD Trunk)
Alarm Level On/Off
Board
Any Any
WARNING
MAJ/MIN/WRN ** ON
Test to Clear
Value
test port sh
release trunk
159