Table of Contents
Advertisement
Fuel Supply System
Fuel Line/Quick-Connect Fitting Installation (cont'd)
4. Align the quick-connect fittings with the line (A),
and align the retainer (B) locking pawls with the
connector (C) grooves. Then press the quick-
connect fittings onto the line until both retainer
pawls lock with a clicking sound.
NOTE: If it is hard to connect, put a small amount of
new engine oil on the line end.
Connection with new retainer:
Reconnection to existing retainer:
11-226
C
B
A
C
B
A
5. Make sure the connection is secure and that the
pawls are firmly locked into place; check visually
and by pulling the connector.
6. Reconnect the battery negative cable, and turn the
ignition switch ON (II). The fuel pump will run for
about 2 seconds, and fuel pressure will rise. Repeat
two or three times, and check that there is no
leakage in the fuel supply system.
Advertisement
Chapters
Table of Contents
Troubleshooting
