Fuel Pump Replacement - Honda 2004 Odyssey Service Manual

Fuel Supply System

Fuel Pump Replacement

Special Tools Required
Fuel sender wrench 07XAA-001010A
1. Remove the second row seats and carpet (see page
20-65).
2. Remove the access panel from the floor (see page
11-223).
3. Turn the ignition switch OFF, then disconnect the
fuel tank unit 5P connector.
4. Remove the fuel fill cap.
5. Relieve the fuel pressure (see page 11-215).
6. Disconnect the quick-connect fittings from the fuel
tank unit.
7. Using the tool, loosen the fuel tank unit locknut (A).
A
93 N·m (9.5 kgf·m, 69 lbf·ft)
11-230
07XAA-001010A
8. Remove the bracket (A), the fuel filter (B), the fuel
gauge sending unit (C), the case (D), and the wire
harness (E).
G
H
C
9. When connecting the fuel pump, make sure the
connection is secure and the suction filter (F) is
firmly connected to the fuel pump (G).
10. Check these items before installing the fuel tank
unit:
• When connecting the wire harness, make sure
the connection is secure and the connectors (H)
are firmly locked into place.
• Do not push the lower part of the suction filter.
• When installing the fuel gauge sending unit,
make sure the connection is secure and the
connector is firmly locked into place. Be careful
not to bend or twist it excessively.
11. Install the parts in the reverse order of removal
with a new base gasket (I). When installing the fuel
tank unit, align the marks (J) on the unit (K) and the
fuel tank (L).
NOTE: Place the base gasket for the fuel tank unit
on the tank first, then carefully insert the fuel tank
unit. If the fuel tank unit is incorrectly installed, the
MIL can come on with DTC P1456.
A L
J
B
K
H
E
H
F
D
I