ip ospf interface type
Configures the OSPF interface type.
ip ospf interface {interface_name} type {point-to-point | point-to-multipoint | broadcast | non-broad-
cast}
Syntax Definitions
interface_name
point-to-point
point-to-multipoint
broadcast
non-broadcast
Defaults
parameter
broadcast | non-broadcast |
point-to-point|
point-to-multipoint
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command sets an interface to be broadcast, non-broadcast, point-to-point, or point-to-multipoint.
•
If the type is non-broadcast or point-to-multipoint, static neighbors should be configured.
Examples
-> ip ospf interface vlan-101 type non-broadcast
Release History
Release 6.1; command was introduced.
Release 6.2.1; ip_address parameter deprecated.
page 22-38
The name of the interface.
Sets the interface to be a point-to-point OSPF interface.
Sets the interface to be a point-to-multipoint OSPF interface.
Sets the interface to be a broadcast OSPF interface.
Sets the interface to be NBMA (Non Broadcast Multi Access) OSPF
interface.
default
broadcast
OmniSwitch CLI Reference Guide
OSPF Commands
June 2012