Igmp Schema Objects; Policy Schema Objects; Table 26: Igmp Schema Objects; Table 27: Policy Schema Objects - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

All the schema if-stats objects in Table 25 on page 216 apply to both layer 2 and layer
3 interfaces, except usdAcctngSpoofedPkts, which is specific to layer 3.
Defining all interface types before you map a collector to the if-stats schema ensures
that you display statistics for all configured interfaces in the first interval.
You can get more accurate rate statistics by using the time-offset parameter. To use
this parameter you must navigate to the if-stats subtreelist. The time-offset
parameter is included in each bulk statistics interface record and is the offset from
the master interval at which the record was collected.

IGMP Schema Objects

Table 26 on page 217 describes the IGMP objects that you can configure using the
bulkstats schema subtree igmp command.

Table 26: IGMP Schema Objects

Object Definition
all Configure IGMP schema for all attributes
dest-address Configure IGMP schema for destination address
igmp-cmd Configure IGMP schema for IGMP command
lower-interface Configure IGMP schema for lower interface
multicast-group Configure IGMP schema for multicast group
router-index Configure IGMP schema for router index
source-address Configure IGMP schema for source address
time-stamp Configure igmp schema for time stamp

Policy Schema Objects

Table 27 on page 217 describes the policy objects that you can configure using the
bulkstats schema subtree policy command.

Table 27: Policy Schema Objects

Object
all
green-bytes
green-packets
red-bytes
Definition
Configure policy schema for all statistics
Configure policy schema for green bytes
Configure policy schema for green packets
Configure policy schema for red bytes
Collecting Bulk Statistics
Chapter 4: Configuring SNMP
217