Configuring Igmp (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 58: GVRP Configuration Fields
Option Function
Disable Select this option to disable GVRP on the interface.
Join Timer Specifies the maximum number of milliseconds the interfaces wait before
sending VLAN advertisements.
Leave Times Specifies the number of milliseconds an interface must wait after receiving
a leave message to remove the interface from the VLAN specified in the
message.
Leaveall Times Specifies the interval at which Leave All messages are sent on interfaces.
Leave All messages help to maintain current GVRP VLAN membership
information in the network.

Configuring IGMP (NSM Procedure)

94
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices for more information.
Internet Group Management Protocol (IGMP) is an Internet protocol that provides a way
for an IP host to report its multicast group membership to adjacent devices. This feature
enables you to associate the IGMP with an interface and allocate it to a multicast group.
To configure IGMP in NSM:
In the navigation tree select
1.
In the Devices list, double click the device to select it.
2.
Click the
Configuration
3.
In the configuration tree, expand
4.
Add/Modify the parameters as specified in Table 59 on page 95.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
Device Manager > Devices
tab.
Protocols and select
Your Action
Click to select.
Select a value.
Select a value.
Select a value.
.
IGMP .
Copyright © 2010, Juniper Networks, Inc.