Accessing L2C Neighbor Configuration Mode For Ancp; Defining An Ancp Neighbor - Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Accessing L2C Neighbor Configuration Mode for ANCP

Use the neighbor command to create an ANCP neighbor and access the L2C Neighbor
Configuration (config-l2c-neighbor) mode.
neighbor

Defining an ANCP Neighbor

The L2C Neighbor Configuration mode enables you to define an ANCP neighbor by
specifying a neighbor ID and the maximum number of branches that the neighbor
can have.
id
max-branches
Use to create an ANCP neighbor and access the L2C Neighbor Configuration
(config-l2c-neighbor) mode.
Example
host1(config-l2c)#neighbor ACCESS-NODE-1
host1(config-l2c-neighbor)#
Use the no version to remove a specific ANCP neighbor configuration or, by
omitting the neighbor name, all ANCP neighbor configurations.
See neighbor.
Use to specify the ANCP neighbor ID in the L2C Neighbor Configuration
(config-l2c-neighbor) mode.
Example
host1(config-l2c)#neighbor
host1(config-l2c-neighbor)#id 1234.5678.9123
Use the no version to remove the neighbor ID.
See id.
Use to specify the maximum number of branches the ANCP neighbor can have.
Example
host1(config-l2c-neighbor)#max-branches 50
Use the no version to return the maximum number of branches to its default
value, unlimited branches.
See max-branches.
Chapter 7: Configuring ANCP
Configuring ANCP Neighbors
199