Monitoring The Policy Configuration Of Layer 2 Services Over Mpls - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Related
Documentation

Monitoring the Policy Configuration of Layer 2 Services over MPLS

Purpose
Action
Copyright © 2010, Juniper Networks, Inc.
Table 39: show ipv6 interface Output Fields (continued)
Field Name
rate-limit-profile
classifier-group entry
Committed
Conformed
Exceeded
queue, traffic class, bound to ipv6
Queue length
Dropped committed packets, bytes
Dropped conformed packets, bytes
Dropped exceeded packets, bytes
show ipv6 interface
Display status and configuration information about layer 2 services over MPLS (also
known as Martini, or layer 2 transport) on the router or on specific interfaces. Displays
only layer 2 circuits for the specified interface.
To display information about layer 2 services over MPLS policy lists:
host1#show mpls l2transport interface
FastEthernet9/0.1
routed to 222.9.1.3 on base LSP
group-id 2 vc-id 900001 mtu 1500
State UP
In Label 48 on stack
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Out Label 49 on tun mpls:lsp-de090100-24-37
0 pkts, 0 hcPkts, 0 octets
Chapter 9: Monitoring Policy Management
Field Description
Name of the profile
Entry index
Number of packets and bytes that conform to
the committed access rate
Number of packets and bytes that exceed the
committed access rate but conform to the peak
access rate
Number of packets and bytes that exceed the
peak access rate
Queue and traffic class bound to the specified
IPv6 interface
Number of bytes in the queue
Total number of committed packets and bytes
dropped by this interface
Total number of conformed packets and bytes
dropped by this interface
Total number of exceeded packets and bytes
dropped by this interface
tun mpls:lsp-de090100-24-37
193