Wiring The Control Circuit Terminal - YASKAWA GA700 Series Technical Manual

Wire Gauge
mm 2 (AWG)
0.25 (24) AI 0.25-8YE
0.34 (22) AI 0.34-8TQ
AI 0.5-8WH,
0.5 (20)
AI 0.5-8OG
◆

Wiring the Control Circuit Terminal

WARNING! Electrical Shock Hazard. Do not remove covers or touch circuit boards while the drive is energized. If you touch the
internal components of an energized drive, it can cause serious injury or death.
NOTICE: Do not let wire shields touch other signal lines or equipment. Insulate the wire shields with electrical tape or shrink
tubing. If you do not insulate the wire shields, it can cause a short circuit and damage the drive.
Note:
• Isolate control circuit wiring from main circuit wiring (terminals R/L1, S/L2, T/L3, R1/L11, S1/L21, T1/L31, B1, B2, U/T1, V/T2, W/
T3, -, +1, +2, +3) and other high-power wiring. If control circuit wiring is adjacent to main circuit wiring, it can cause incorrect
operation of the drive and equipment from electrical interference.
• Isolate wiring for contact output terminals MA, MB, MC and M1-M6 from other control circuit wiring. If contact output terminal
wiring is adjacent to other control circuit wiring, it can cause incorrect operation of the drive and equipment from electrical
interference.
• Use a Class 2 power supply to connect external power to the control terminals. If the power supply for peripheral devices is incorrect, it
can cause a decrease in drive performance.
• Connect the shield of shielded cable to the applicable ground terminal. Incorrect equipment grounding can cause drive or equipment
malfunction from electrical interference.
Correctly ground the drive terminals and complete main circuit wiring before you wire the control circuit.
Remove the keypad and front cover.
1.
Push in on the tabs on the both sides of the LED status ring board to release the board from the bracket.
Pull the board forward to remove it.
NOTICE: When you remove the LED Status Board from the drive bracket, make sure that you temporarily install it in
the holding position provided on the drive. If you cause damage to the LED status ring board, the LEDs will not
function correctly.
Note:
You can temporarily store the LED status ring board with the temporary placement holes on the drive. The location of the
temporary placement holes is different on different drive models.
A - Drive front
B - LED status ring board
YASKAWA SIEPC71061705H GA700 Series Technical Manual
Table 3.13 Crimp Ferrule Models and Sizes
Model L (mm)
12.5
12.5
14
Figure 3.40 Remove the LED Status Ring Board
L1 (mm) φd1 (mm)
8
8
8
C - Temporary placement holes
3.5 Control Circuit Wiring
φd2 (mm)
0.8 2.0
0.8 2.0
1.1 2.5
3
101