4.6 Keypad Operation
Note:
The HOME screen must show U1-01 [Frequency Reference] or you must set the keypad as the Run command source (REMOTE) to use
this function.
■
Show the Main Menu
Push
to show the main menu. Push
◆
Show the Monitor
This section shows how to show the standard monitors (Ux-xx).
1.
Push
[Home] to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown on
2.
Push
(Menu).
3.
Push
or
4.
Push
or
5.
Push
or
6.
Push
or
Note:
Push
to go back to the previous page.
150
[HOME] to go back to the HOME screen.
, push
(Back) to show [Home] on
to select [Monitors], then push
to select [Standard Monitor], then push
to select monitor group, then push
to change the monitor number to show the monitor item.
.
.
.
.
YASKAWA SIEPC71061705H GA700 Series Technical Manual