YASKAWA GA700 Series Technical Manual page 838

12.8 H: Terminal Functions
■
1B: During Baseblock (N.C.)
Setting Value Function
1B During Baseblock (N.C.)
ON : The drive is not in baseblock.
OFF : During baseblock
■
1C: Motor 2 Selected
Setting Value Function
1C Motor 2 Selected
ON : Motor 2 Selected
OFF : Motor 1 Selected
■
1D: During Regeneration
Setting Value Function
1D During Regeneration
ON : Motor is regenerating.
OFF : Motor is operating or stopped.
■
1E: Executing Auto-Restart
Setting Value Function
1E Executing Auto-Restart
The terminal deactivates when the Auto Restart function automatically resets a fault. The terminal deactivates
when the Auto Restart function detects the fault again because there were too many restart attempts as specified
by L5-01 [Number of Auto Restart Attempts].
Note:
Refer to L5: Fault Restart on page 897
■
1F: Motor Overload Alarm (oL1)
Setting Value Function
1F Motor Overload Alarm
(oL1)
Note:
Refer to "L1-01: Motor Overload (oL1) Protection" for more information.
838
Figure 12.102 Reverse Operation Output Time Chart
V/f CL-V/f OLV CLV AOLV
The terminal deactivates during baseblock. When the drive is in baseblock, the drive output transistor stops switching and does
not make DC bus voltage.
V/f CL-V/f OLV CLV AOLV
The terminal activates when you select motor 2.
V/f CL-V/f OLV CLV AOLV
The terminal activates on when the motor is regenerating.
V/f CL-V/f OLV CLV AOLV
The terminal activates when the Auto Restart function is trying to restart after a fault.
for more information.
V/f CL-V/f OLV CLV AOLV
The terminal activates when the electronic thermal protection value of the motor overload protective function is a minimum of
90% of the detection level.
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
YASKAWA SIEPC71061705H GA700 Series Technical Manual