Set The Keypad Language Display - YASKAWA GA700 Series Technical Manual

4.6 Keypad Operation
7.
Follow the messages shown on the keypad to do the next steps.
8.
When the keypad shows the Auto-Tuning start screen, push
Auto-Tuning starts.
When doing Rotational Auto-Tuning, the motor will stay stopped for approximately one minute with power
energized and then the motor will start to rotate.
9.
When the keypad shows this screen after Auto-Tuning is complete for 1 or 2 minutes, push
The keypad will show a list of the changed parameters as the result of Auto-Tuning.
10.
Push or
select [Auto-Tuning Successful] at the bottom of the screen and push
To change a parameter again, push
the parameter setting screen.
Auto-Tuning is complete.
Note:
If the drive detects an error or you push
error code. Endx identifies that Auto-Tuning was successful with calculation errors. Find and repair the cause of the error and do Auto-
Tuning again, or set the motor parameters manually. You can use the drive in the application if you cannot find the cause of the Endx
error. Er-xx identifies that Auto-Tuning was not successful. Find and repair the cause of the error and do Auto-Tuning again.
◆

Set the Keypad Language Display

The procedure in this section shows how to set the language shown on the keypad.
172
in the parameter change confirmation screen to check the changed parameters, then
or
before Auto-Tuning is complete, Auto-Tuning will stop and the keypad will show an
.
to select the parameter to change, then push
YASKAWA SIEPC71061705H GA700 Series Technical Manual
or
.
.
to show