3.4 Main Circuit Terminal Block Wiring Procedure
1.
Pull the wiring cover away from the drive to remove it.
A - Wiring cover
2.
Put the end of a prepared wire into the terminal block.
Note:
If there is a jumper between terminals +1 and +2, loosen the terminal block screws and remove the jumper before wiring the
terminals.
3.
Tighten the screws to the specified torque.
4.
Examine the signal from the wired terminal and use a diagonal-cutting pliers to remove areas of the wiring
cover cutaway section.
To remove the wiring cover, cut off the portion shown in
A - Cutaway sections
90
Figure 3.24 Remove the Wiring Cover
Figure 3.25 Install the Electrical Wire
Figure 3.26 Tighten Terminal Block Screws
Figure 3.27 Clip the Cutaway Section of the Wiring Cover
Figure
3.27.
B - Cut this portion with a diagonal-cutting pliers
YASKAWA SIEPC71061705H GA700 Series Technical Manual