Display Monitors As An Analog Gauge - YASKAWA GA700 Series Technical Manual

3.
Push or
4.
Push or
5.
Push .
6.
Push or
Monitor Set the x-xx part of the Ux-xx. For example, to show monitor U1-01 [Frequency Reference], set it
to "101" as shown in this figure.
The configuration procedure is complete.
◆

Display Monitors as an Analog Gauge

The following explains how to display the contents selected for a monitor as an analog gauge.
1.
Push [Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push [Menu].
YASKAWA SIEPC71061705H GA700 Series Technical Manual
to select [Monitors], then push
to select [Analog Gauge], then push
to select the monitor number to register, then push
, push [Back] to show [Home] on
.
[Setup].
.
.
4.6 Keypad Operation
155
4