YASKAWA GA700 Series Technical Manual page 987

4.6 Keypad Operation
◆ St art Data Logging
The data log function saves drive status information. Monitors
information. The procedure in this section shows how to start logging data.
There are two types of data log functions:
 Long-term data log: Saves data continuously over a long time period.
 Short-term data log: Saves data for a certain time period before and after the detection of
a trigger with a short sampling cycle.
You can record a maximum of 10 monitors for long-term data logs and a maximum of four
monitors for short-term data logs.
1. Make sure that a microSD card is inserted in the keypad.
2. Push (Home) to show the HOME screen.
Note:  When the drive is in HOME Mode, the screen shows [Home] in the upper right-
hand corner of the screen.
 If [Home] is not shown on
3. Push (Menu).
4. Push or
5. Push or
6. Push or
 [Yes]: Data logging starts.
 [No]: Data logging will not start.
Note: The type of data log that will start is displayed at the bottom of the screen.
If the drive was logging data when you entered the command, the keypad look like this:
 The following items are displayed for a long-term data log: start time and elapsed time
of the data log.
, push
to select [Diagnostic Tools], then push
to select [Data Logger], then push
to select [Yes] or [No], then push
Ux-xx are the source of log
(Back) to show [Home] on
.
.
.
D ocu ment No. E ZZ024048<1>
P r epared in October, 2021
.
3 / 19