Show Custom Monitors; Set The Monitors To Show As A Bar Graph - YASKAWA GA700 Series Technical Manual

4.6 Keypad Operation
The configuration procedure is complete.
◆

Show Custom Monitors

The procedure in this section shows how to show the registered custom monitors.
1.
Push [Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push [Menu].
3.
Push or
4.
Push or
The keypad shows the selected monitor as shown in this figure.
• When there are a minimum of two screens, push
• If you registered only one custom monitor to [Custom Monitor 1], the screen will show only one monitor. If you
registered custom monitors only to [Custom Monitor 1] and [Custom Monitor 2], the screen will show only two
monitors.
◆

Set the Monitors to Show as a Bar Graph

The procedure in this section shows how to show the frequency reference monitor as a bar graph.
152
, push [Back] to show [Home] on
to select [Monitors], then push
to select [Custom Monitor], then push
.
.
.
or to switch between screens.
YASKAWA SIEPC71061705H GA700 Series Technical Manual