YASKAWA GA700 Series Technical Manual page 815

■
43: FWD/REV (2-Wire Sequence 2)
Setting Value Function
43 FWD/REV (2-Wire
Sequence 2)
ON : Reverse Run
OFF : Forward Run
Note:
• You must input the Run command to rotate the motor.
• This function will not operate at the same time as H1-xx = 40, 41 [Forward RUN (2-Wire), Reverse RUN (2-Wire)].
■
44: Add Offset Frequency 1 (d7-01)
Setting Value Function
44 Add Offset Frequency 1
(d7-01)
Note:
Refer to d7: Offset Frequency on page 737
■
45: Add Offset Frequency 2 (d7-02)
Setting Value Function
45 Add Offset Frequency 2
(d7-02)
Note:
Refer to d7: Offset Frequency on page 737
■
46: Add Offset Frequency 3 (d7-03)
Setting Value Function
46 Add Offset Frequency 3
(d7-03)
Note:
d7: Offset Frequency on page 737
Refer to
■
47: Node Setup (CANopen)
Setting Value Function
47 Node Setup (CANopen)
■
60: DC Injection Braking Command
Setting Value Function
60 DC Injection Braking
Command
If you input the Run command or JOG command, it will cancel DC Injection Braking.
Figure 12.88 shows the time chart of the DC Injection Braking function.
YASKAWA SIEPC71061705H GA700 Series Technical Manual
V/f CL-V/f OLV CLV AOLV
Sets the direction of motor rotation for 2-wire sequence 2. Set this function and H1-xx = 42 [Run Command (2-Wire Sequence
2)] together.
V/f CL-V/f OLV CLV AOLV
Sets the function to add the offset frequency set in d7-01 [Offset Frequency 1] to the frequency reference when the terminal
activates.
for more information.
V/f CL-V/f OLV CLV AOLV
Sets the function to add the offset frequency set in d7-02 [Offset Frequency 2] to the frequency reference when the terminal
activates.
for more information.
V/f CL-V/f OLV CLV AOLV
Sets the function to add the offset frequency set in d7-03 [Offset Frequency 3] to the frequency reference when the terminal
activates.
for more information.
V/f CL-V/f OLV CLV AOLV
Sets the function in CANopen communications to start the Node Setup function to set the drive node address from the host
controller.
V/f CL-V/f OLV CLV AOLV
Sets the command to use DC Injection Braking to stop the motor.
12.8 H: Terminal Functions
Description
OLV/PM OLV/PM AOLV/PM CLV/PM EZOLV
Description
OLV/PM OLV/PM AOLV/PM CLV/PM EZOLV
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
12
815