Connect Braking Units In Parallel - YASKAWA GA700 Series Technical Manual

3.9 Braking Resistor Installation
5.
Remove the main circuit terminal block nut.
A - Nut
6.
Wire the closed-loop crimp terminal to the main circuit terminal block.
7.
Tighten the nut to the specified torque.
8.
Attach the wiring cover and terminal block cover to their initial positions and tighten the screws on the
terminal block cover.
9.
Put the terminal cover back in its initial position.
◆

Connect Braking Units in Parallel

To connect two or more braking units in parallel, refer to
116
Figure 3.68 Remove the Terminal Block Nut
Figure 3.69 Connect the Wire
Figure 3.70 Tighten the Terminal Block Nut
Figure 3.71 Reattach the Wiring Cover
Figure 3.72 for wiring and connector selections.
YASKAWA SIEPC71061705H GA700 Series Technical Manual