Show Monitors As Bar Graphs; Set The Monitors To Show As Analog Gauges - YASKAWA GA700 Series Technical Manual

4.6 Keypad Operation
◆

Show Monitors as Bar Graphs

The procedure in this section shows how to show a specific monitor as a bar graph. You can show a maximum of
three.
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for
2.
Push (Menu).
3.
Push or
4.
Push or
The screen will show the monitors as shown in this figure.
◆

Set the Monitors to Show as Analog Gauges

The procedure in this section shows how to show the frequency reference monitor as an analog gauge.
1.
Push [Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push [Menu].
154
, push
to select [Monitors], then push
to select [Display Bar Graph], then push
, push [Back] to show [Home] on
(Back), and then push
.
.
.
YASKAWA SIEPC71061705H GA700 Series Technical Manual
to show [Home].