Disable The Initial Setup Screen; Start Data Logging - YASKAWA GA700 Series Technical Manual

◆

Disable the Initial Setup Screen

Do the steps in this procedure to not show the initial start-up screen when the drive is energized.
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for
2.
Push (Menu).
3.
Push /
4.
Push /
5.
Push /
• [No]: The keypad will not show the Initial Setup Screen when the drive is energized.
• [Yes]: The keypad will show the Initial Setup Screen when the drive is energized.
◆

Start Data Logging

The data log function saves drive status information. Monitors Ux-xx are the source of log information. The
procedure in this section shows how to start logging data.
You can record a maximum of 10 monitors.
1.
Make sure that a microSD card is inserted in the keypad.
2.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown on
YASKAWA SIEPC71061705H GA700 Series Technical Manual
, push
to select [Initial Setup], then push
to select [Show Initial Setup Screen], then push
to select [No], then push
, push (Back) to show [Home] on
(Back), and then push
.
.
.
.
4.6 Keypad Operation
to show [Home].
4
177